
3.26 ZyDASTURBOMODE
This chapter describes how to enhance the performance by enabling the AIR802 turbo mode.
Turbo mode is a composition of Burst Mode and Large Packet Mode.
You may be aware that the so-called “Turbo Mode” always has compatibility problems. In order
to achieve the highest performance, you need to use the AIR802 adapter with the ZyDAS
chipset in both AP and Station mode. The Turbo mode is available on the AIR802 USB-ADG-2
adapter with the Linux driver only at this time. Currently, AIR802 supports it in Infrastructure
Mode only. You could enable both to achieve maximum performance.
3.27 ENABLEBURSTMODE
To enable burst mode, you need to issue the following commands.
To enable burst mode:
iwpriv ethX 1p_mode 4
To disable burst mode:
iwpriv ethX 1p_mode 5
In Infrastructure mode, you need to re-associate with the AP to update you Turbo Mode status.
3.28 LARGEPACKETMODE
In Large Packet mode, small frames are merged into a large frame. It can save inter-frame
spacing time to raise the performance level. The command to activate large packet mode is:
To enable:
iwconfig ethX rts off
iwpriv ethX 1p_mode 1
To disable:
iwpriv ethX 1p_mode 0
Setting to “enable” will result in small packets being placed with others into one frame. The
receiving capability is always on. For AP mode with 1p_mode=1, it sends large packets to a
station only when the last frame from that station is a large packet. Therefore, the AP can
communicate with a station capable of large packets or not. In Station mode, you need to re-
associate with the AP to update your Turbo Mode status.
There is something to keep in mind. Large packets are a result of merging smaller into one
larger frame. In other words, when there is only one frame in queue, it could take some time to
wait for another frame. If the next one comes too late or doesn’t come, it will be sent by an
expiry check timer. It could result in lower performance than normal mode. Our experience
shows two traffic flows achieve best performance. Fragmentation isn’t allowed when Large
Packet mode is set.
23
Comentarios a estos manuales